服务器连接外接的存储器时无法启动

发布网友 发布时间：2022-05-12 04:21

我来回答

共2个回答

热心网友 时间：2023-08-11 17:33

可能是你的服务器较新，采用了新的启动技术，叫做UEFI，这种技术默认首先从存储查找磁盘引导设备，但由于存储上并没有相应的引导设备，所以启动会失败。解决的办法就是将最新的系统启动技术UEFI修改为传统的启动技术，修改方法如下：
1. Power on or restart the system and pressF1 when prompted to enter Setup.
2. Select System Settings and pressEnter.
3. Select Devices and I/O Ports andpress Enter.
4. Select Enable/Disable Legacy OptionROMs and press Enter.
5. Under Enable/Disable Legacy OptionROMs select the slot number in which the HBA is installed and press Enter.
6. Select Disabled and press Enter.
7. Under Enable/Disable UEFI Option ROMs selectthe slot number in which the HBA is installed and press Enter.
8. Select Disabled and press Enter.
9. Press Esc 3 times toreturn to the System Configuration main menu, select Save Settings and press Enter.
10. Select Boot Manager and pressEnter.
11. Select Add BootOption and press Enter.
12. Select Legacy Only and press Enter
13. Press Esc to return to Boot Manager.
14. Select Change Boot Order andpress Enter.
15. Select the existing Boot Order and press Enter.
16. Select Legacy Only and press the + key to promote it to aposition above the local device which contains the operating system .Typically, this would be above Hard Disk 0. Press Enter
17. Select Commit Changes and pressEnter.
18. Press Esc to return to Boot Manager.
19. Select Reset System and pressEnter
注意：在设置启动顺序的时候将"Legacy Only"设置在"Hard Disk 0"前面，且"Hard Disk 0"要紧跟在"Legacy Only"启动项后面！

这些内容虽然网上也能搜索到，但我是从内部资料找来复制给你的，算纯手打。你试试看

热心网友 时间：2023-08-11 17:33

存储要是正常的话那就是HBA卡或线有问题了,更换试试.