请高手帮我将以下说明书翻译成英文版的,谢谢
发布网友
发布时间：2022-05-12 11:43
共2个回答
热心网友
时间：2023-10-08 17:52
Automatic control based on infrared technology procts, when someone entered the scope of switch sensors, special sensors to detect changes in infrared spectra of human, switch automatically connect the load, the scope of activities in the sensors, switches will continue to get through; left, switch self-closing delay load. To the lights, were out from the lamp, warm, safe energy.
. Automatic Metering:: sensor light is not strong (default setting), with photoreceptor-conditioning, but also under the regulation of light in any or all-day inction sensors.
. Automatic random delay (for delay may be the way): the scope of activities in the sensors, switches, always connected, until the people left after the self-closing.
. Mine functions: the Ad Hoc Lightning devices, can be effective in preventing high-pressure moments, such as lightning damage to the switch.
. Adjustable delay time: time lights automatically superimposed in lights if it was in its exploration activities in the region, and its lights in time to detect signal each time after re-timing, automatic lights to extend the time -360 seconds 8 seconds adjustable.
Installation and use:
. The installation of this proct is limited to use in the lamp body, should avoid the proct is installed in the vicinity of the sun and direct air flow, temperature changes in significant areas such as: air-conditioning, heaters, will affect the sensitivity of the sensor.
. In order to ensure maximum detection range, the proct should be installed high above the ground in the 1.8 ~ 2.5 m
. Do not use sharp or hard objects to detect touch毛糙window pollutants
. After installation, connect the power before the delay knob counter-clockwise rotation to the smallest, light control adjustment knob clockwise to the largest electric lights should be lit after about 40 seconds or so, until extinguished after 5 seconds inction, if everything is normal, delay knob can be set according to their own needs time lights, moving light control rotary knob to adjust the working environment illumination settings.
. This proct can only be used for such purposes, if used for other purposes or to connect to the wrong caused by the loss of manufacturing will not bear any responsibility.
Technical parameters:
1. Rated Voltage / frequency: AC 220-240V/50-60HZ
2. Ambient temperature: -10 ° C - +45 ° C / +40 ° C
3. Load Type: tungsten
4. Load rated power / current: max.250W/1A
5. Inction distance: ≤ 6 meters
6. Sensor angle: ≤ 120 degrees
7. Latency time: -6 minutes 8 seconds
8. Environmental illuminance: <10-250LUX
9. Mounting height: 1.8 ~ 2.5 m
Wiring diagram: Schematic diagram of the detection range:
热心网友
时间：2023-10-08 17:53
希望你能找到满意的答案
